Discoverflow | Trinidad | FAQ | tv

Your remote control is simple to program, easy to use, and can operate up to five devices, including cable set top terminals, televisions, VCRs, DVDs and audio for CD players. Before you can use your remote control, it must be programmed (set up) to operate the above devices.

Before you get started

Some of the special features and buttons on your remote control are as follows:

Memory Guard®

Eliminates reprogramming after battery changes.

Time Out

Shuts remote off if any button is pressed and held for 45 seconds. This extends battery life in the event the remote becomes lodged under or between heavy objects.

Reset

Lets you reset your remote to its original default settings. To do this press, the CABLE and OK button together and hold both buttons down until the CABLE button lights up. Then press MENU, then MENU again. The CABLE button will blink and go out.

Install two new AAA alkaline batteries as indicated by the diagram in the battery compartment. When the batteries become low and need to be replaced, the SAT, TV, VCR, DVD, AUDIO buttons will not illuminate normally or at all during use. When this happens, replace the existing batteries with two new AAA alkaline batteries. Your remote control has Memory Guard which eliminates the need for reprogramming after battery changes.

It’s also pre-programmed to operate Motorola DCT digital set top terminals. If, for some reason, you need to set your remote to operate your set top box, follow the instructions below:

1. Press OK/SEL, then press MUTE together until the power/mode buttons illuminate in slow rotation (i.e. CABLE > TV > VCR > DVD > AUDIO > CABLE)

2. The three digit code for the Motorola DCT is 001. Enter this into the keypad of the remote control. The cable set top terminal will turn off.

3. Then, press OK/SEL to lock in the code. The POWER button will blink 3 times and go out.

 

Here’s a list of remote control basics.

Power

Turn on your TV

Press the TV button

Turn on your set top box

Press the CBL button

Turn on your VCR

Press the VCR button

Audio

Set up your audio

Press the MENU button until the Settings Menu appears. Press the downward triangle to highlight Audio Preference and SELECT/OK to display options. Highlight and adjust each option to your liking. For help with options, press MENU.

Adjust the volume

Press the +VOL- button

Changing channels

Channel surf

Press the +CH- button

Select a specific channel

Use the number buttons to enter a channel number

Select the previous channel

Press the LAST button

Surf Favourites

First, make a list of your favourite channels in the Settings Menu. Then, while viewing your TV, press the FAV button to surf from one channel to the next.

Please note: you may have to program your remote control buttons before being able to use them.

Got any additional questions? We are happy to help!

Chat

Choose a service